Mitsubishi Lancer Evolution Evo 7 8 9 MR 45mm Angled Triple Gauge Pod Trim

Description

This is a 3D-printed gauge pod/holder designed for the factory Lamco® gauges that came standard on all Evo 8/9 MR's. The gauges are originally located in the lower cubby near the shifter which are almost impossible to view while driving. A common solution is to switch the location of these gauges with the radio, however the gauges are still not angled for optimal viewing and they are also now exposed to sunlight through the windshield. The faces and needles
will
get faded over time! This gauge pod was designed to remedy these issues by angling the gauge faces towards the driver for better visibility and recess the gauges for protection against the sun exposure. This is what the Evo 8/9 MR's should have came with from the factory!
100% bolt-on installation, no modifications needed
Works for LHD and RHD vehicles (flip for correct direction)
Made of PET-G for great heat resistance, impact resistance, durability and superior UV resistance
Hardware is quality stainless steel
Designed to work with existing mounting hardware on the MR gauges
Strategically printed with calibrated print settings for a smooth front face and a factory finish
Large mounting holes allow for slight variance in positioning, if needed
DOES NOT INCLUDE GAUGES. GAUGES SHOWN ONLY FOR REFERENCE.
All gauge pods come pre-assembled
Designed, printed and assembled in the USA!